Replacing the chassis management card in the EMX0 PCIe3 expansion
drawer
To replace the chassis management card in the EMX0 PCIe3 expansion drawer, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Slide the chassis management card completely into the slot and push the lever (A) up to secure the
card. See Figure 6.
A
Figure 6. Replacing the chassis management card
3. Connect the power cord (A) to the power supply (C), as shown in Figure 7 on page 6. Repeat this step
for the remaining power supply.
Chassis management card
5