Chassis Management Card For The Emx0 Pcie Gen3 I/O Expansion Drawer; Removing And Replacing The Chassis Management Card In The Emx0 Pcie3 Expansion Drawer; Preparing The System To Remove And Replace The Chassis Management Card From The Emx0 Pcie3 Expansion Drawer - IBM Power Systems EMX0 PCIe Gen3 Manual

Chassis management card for the EMX0 PCIe Gen3 I/O
expansion drawer
Learn how to remove, and replace a chassis management card in the EMX0 PCIe Gen3 I/O expansion
drawer (EMX0 PCIe3 expansion drawer).
The following procedures describe the removal and replacement of the chassis management card.
Replacing this field-replaceable unit (FRU) must be completed by an authorized service representative.
Removing and replacing the chassis management card in the EMX0
PCIe3 expansion drawer
Learn how to remove and replace the chassis management card in the EMX0 PCIe3 expansion drawer.
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part
in the system. For instructions, see "Repairing a part by using the HMC" on page 21.
If you do not have an HMC, complete the following steps to prepare the system to remove the chassis
management card:
1. "Preparing the system to remove and replace the chassis management card from the EMX0 PCIe3
expansion drawer"
2. "Removing the chassis management card from the EMX0 PCIe3 expansion drawer" on page 3
3. "Replacing the chassis management card in the EMX0 PCIe3 expansion drawer" on page 5
4. "Preparing the system for operation after removing and replacing the chassis management card in the
EMX0 PCIe3 expansion drawer" on page 6
Preparing the system to remove and replace the chassis management
card from the EMX0 PCIe3 expansion drawer
To prepare the system to remove and replace the chassis management card in the EMX0 PCIe3 expansion
drawer, complete the steps in this procedure.
Procedure
1. Identify the system that you are working on. For instructions, see "Control panel LEDs" on page 12
and Enabling enclosure or server indicators with the ASMI.
2. Complete the prerequisite tasks. For instructions, see "Before you begin" on page 9.
3. Stop the system and the EMX0 PCIe3 expansion drawer. When you stop the system, the EMX0 PCIe3
expansion drawer powers off automatically. For instructions, see "Stopping a system or logical
partition" on page 17.
4. Remove the front cover by removing the screws (B) and then pulling the front cover (A) away from
the EMX0 PCIe3 expansion drawer by using your fingers. See Figure 1 on page 2.
© Copyright IBM Corp. 2015, 2016
1