Gud Variables That Can No Longer Be Used - Siemens SINUMERIK 840D sl Programming Manual

A.5

GUD variables that can no longer be used

The following GUD variables can generally no longer be programmed as of measuring
cycles version 2.6! If machine or setting data is assigned to a GUD variable, only this data
should be used!
GUD up to Version 7.5
_CVAL[0]
_CVAL[1]
_CVAL[2]
_CVAL[3]
_PROTNAME
_HEADLINE
_PROTFORM
_PROTSYM
_PROTVAL
_PMI
_SP_B
_TXT
_DIGIT
_SI[n]
_SM_R[n]
_SM_I[n]
_SM_B[n]
_SH_I[n]
_SH_B[n]
_JM_I[n]
_M_TNIC
_JM_B[0]
_JM_B[1]
_JM_B[2]
_JM_B[3]
_JM_B[4]
_JM_B[5]
_JM_B[6]
_SMI_I[2]
_SMI_I[3]
E_MESS_IS_METRIC
E_MESS_IS_METRIC_SPEZ_VAR
E_MESS_MS_IN
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Changes from cycle version SW4.4 and higher
A.5 GUD variables that can no longer be used
MD/SD version 2.6
SD55761 $SCS_J_MEA_SET_NUM_OF_ATTEMPTS
SD55762 $SCS_J_MEA_SET_RETRAC_MODE
SD55763 $SCS_J_MEA_SET_FEED_MODE
SD54691 $SNS_MEA_T_PROBE_OFFSET
SD54690 $SNS_MEA_T_PROBE_MANUFACTURER
MD51606 $MNS_MEA_INPUT_PIECE_PROBE[0]
267