Siemens SINUMERIK 840D sl Programming Manual page 222

Parameter lists
3.1 Overview of measuring cycle parameters
No. Screen form Cycle
parameters parameters
S_KNUM1
3 Selection
S_PRNUM
4 Icon+
number
5 X0 S_SETV
6 X S_MA
7 X1 S_SZA
S_SZO
8 Y1
9 DFA S_FA
10 TSA S_TSA
11 Measureme S_NMSP
nts
S_TNAME
12 T
13 DL S_DLNUM
14 TZL S_TZL
15 DIF S_TDIF
S_TUL
16 TUL
17 TLL S_TLL
18 TMV S_TMV
222
Meaning
Correction in tool offset
2), 4)
Values: UNITS:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset;
for additive and setup offset, see also
THOUSANDS: Reserved
TEN THOUSANDS: Tool offset
0 = No specification (offset of tool radius normal, not inverted)
1 = Offset inverted
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset of tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
MILLIONS: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry;
Number of the field of the probe parameters (not probe number)
(default=1)
Setpoint
Number of the measuring axis (default=1)
Values: 1 = 1st axis of the plane (for G18 Z)
2 = 2nd axis of the plane (for G18 X)
3 = 3rd axis of the plane (for G18 Y)
Length of the protection zone in the measuring axis
Length of the protection zone in the traverse axis
Measurement path
Safe area
Number of measurements at the same location
Tool name
3)
Setup additive offset DL number
Work offset
2), 4)
Dimensional difference check
Upper tolerance limit
4)
Lower tolerance limit
4)
Offset range for averaging
S_DLNUM
2)
2)
2)
5)
5)
5)
8)
(default=1)
2)
5)
2), 4)
2)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measuring cycles