Siemens SINUMERIK 840D sl Programming Manual page 89

List of the result parameters
The measuring variant "Radius in Ring" provides the following result parameters:
Table 2- 10
Parameters
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [8]
_OVR [9]
_OVR [10]
_OVR [11]
_OVR [12]
_OVR [13]
_OVR [14]
_OVR [15]
_OVR [20]
_OVR [21]
_OVR [24]
_OVR [27]
_OVR [28]
_OVI [2]
_OVI [5]
_OVI [9]
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Radius in ring" result parameters
Description
Actual value probe ball diameter
Difference probe ball diameter
Center point of calibration ring in 1st axis of the plane
Center point of calibration ring in 2nd axis of the plane
Trigger point in minus direction, actual value of 1st axis of the plane
Trigger point in minus direction, difference of 1st axis of the plane
Trigger point in plus direction, actual value of 1st axis of the plane
Trigger point in plus direction, difference of 1st axis of the plane
Trigger point in minus direction, actual value of 2nd axis of the plane mm
Trigger point in minus direction, difference of 2nd axis of the plane
Trigger point in plus direction, actual value of 2nd axis of the plane
Trigger point in plus direction, difference of 2nd axis of the plane
Positional deviation of the 1st axis of the plane (probe skew)
Positional deviation of the 2nd axis of the plane (probe skew)
Angle at which the trigger points were determined
Zero offset area
Safe area
Measuring cycle number
Probe number
Alarm number
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
-
-
-
89