Siemens SINUMERIK 840D sl Programming Manual page 199

Sequence
Before CYCLE 982 is called, the tool must be aligned in the same way as it will eventually be
measured.
The tool should be preferably aligned with CYCLE800, refer to the Operating Manual
Turning
Please note that the measuring cycle assumes that the tool has been aligned in advance.
From the position adopted by the tool, it must be possible to approach the probe in X, Z via
the measuring cycle.
The measuring procedure that follows is the same as for the measuring variants when the
tool carrier is in its basic position.
Note
Measuring milling tools
The following measuring version is not supported when using a tool carrier that can be
orientated:
Measuring type: "complete" and cutting edge: measure "rear side".
When this measuring version is used, alarm 61037: "Incorrect measuring version" is output.
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
, Chapter "Swivel plane/align tool (CYCLE800)".
Measuring variants
2.4 Measure tool (turning)
199