Compensation strategy
The tool measuring cycle is intended for various applications:
● Initial measurement of a tool (general setting data SD 54762
● Post measurement of a tool (general setting data SD 54762
Empirical values may optionally be included. A mean value is not calculated.
See also
Changes from cycle version SW4.4 and higher (Page 257)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Note
Workpiece-related or machine-related measurement requires an appropriately
calibrated tool probe, see ChapterCalibrate probe (CYCLE982) (Page 178).
$SNS_MEA_FUNCTION_MASK_TOOL Bit9):
The tool offset values in geometry and wear are replaced.
The offset is applied in the geometry component of the particular length.
The wear component is deleted.
$SNS_MEA_FUNCTION_MASK_TOOL Bit9):
The resulting difference is calculated into the wear component (length) of the tool.
Measuring variants
2.4 Measure tool (turning)
177