Siemens SINUMERIK 840D sl Programming Manual page 275

Measurement result display
Measurement result displays can be shown automatically during measuring cycle runtime.
The function is dependent on the settings in the channel-specific SD 55613
$SCS_MEA_RESULT_DISPLAY.
Measuring accuracy
The measurement accuracy that can be obtained is dependent on the following factors:
● Repeat accuracy of the machine
● Repeat accuracy of the probe
● Resolution of the measuring system
The repeat accuracy of the controls for "on-the-fly measurement" is ±1 µm.
Measuring at an angle
A measurement version used to measure a hole, spigot (shaft), groove, or a web at any
angle. The measurement path is traveled at a certain set angle defined in the WCS.
Measuring blanks
The blank measurement determines the position, deviation, and work offset of the workpiece
in the result of a → workpiece measurement.
Measuring in JOG
It contains the following functions:
● Semi-automatic calculation of tool geometry and storage in the tool offset memory
● Semi-automatic calculation and setting of reference points and storage in work offset
The function is operated with softkeys and input displays.
Measuring version
The measuring version of each measuring cycle is defined in parameter
parameter can have certain integer values for each measuring cycle, which are checked for
validity within the cycle.
Mono probe
A mono(directional) probe is a probe that can only deflect in one direction. It can only be
used for workpiece measurement on milling machines and machining centers with slight
limitations.
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
memory
Glossary
. The
S_MVAR
275