Siemens SINUMERIK 840D sl Programming Manual page 219

No. Screen form Cycle
parameters parameters
S_KNUM1
3 Selection
S_PRNUM
4 Icon+
number
5 X0 S_SETV
6 X S_MA
7 DFA S_FA
S_TSA
8 TSA
9 α S_STA1
10 Measureme S_NMSP
nts
11 T S_TNAME
S_DLNUM
12 DL
13 TZL S_TZL
14 DIF S_TDIF
15 TUL S_TUL
S_TLL
16 TLL
17 TMV S_TMV
18 FW S_K
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Correction in tool offset
2), 4)
Values: UNITS:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset;
for additive and setup offset, see also
THOUSANDS: Reserved
TEN THOUSANDS: Tool offset
0 = No specification (offset in tool radius normal, not inverted)
1 = Offset inverted
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
MILLIONS: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
Number of the field of the probe parameters (not probe number)
(default=1)
Setpoint
Measuring axis (number of the axis) (default=1)
Values: 1 = 1. axis of the plane (for G18 Z)
2 = 2nd axis of the plane (for G18 X)
3 = 3rd axis of the plane (for G18 Y)
Measurement path
Safe area
Starting angle for measurement with reversal
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
2), 4)
Dimensional difference check
Upper tolerance limit
4)
Lower tolerance limit
4)
Offset range for averaging
Weighting factor for averaging
3.1 Overview of measuring cycle parameters
S_DLNUM
2)
2)
2)
5)
5)
5)
5)
(default=1)
2)
5)
2), 4)
2)
2)
Parameter lists
219