Siemens SINUMERIK 840D sl Programming Manual page 237

No. Screen form Cycle
parameters parameters
S_FA
17 DFA
S_TSA
18 TSA
19 Measureme S_NMSP
nts
20 S_MCBIT
21 _DMODE
22 _AMODE
All default values = 0 or marked as the range of values a to b
1)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
2)
) Input of the measuring points in polar coordinates, taking into account the starting angle
3)
or 4 of the incremental angle
Input of the measuring points in the right-angled coordinate system (input using 4 points),
4)
If WO "fine" has not been set up in MDs, correction is made according to WO "coarse"
5)
Value range of angle
7)
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Measurement path
Safe area
Monitoring of the angle difference to the angle setpoint [degrees]
Number of measurements at the same location
Reserved
Display mode
Values: UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
.
S_INCA
: -180 to +180 degrees
S_INCA
3.1 Overview of measuring cycle parameters
(value range 1 to 9)
2)
S_STA1
Parameter lists
6)
2)
for measuring point 3
237