Only If The "Setup Additive Offset" Function Has Been Set-Up In The General Md 18108 $Mn_Mm_Num_Sumcorr . In; Value Range For Empirical Mean Value Memory; To 20 Numbers (N) Of The Empirical Value Memory, See Channel-Specific Sd 55623 $Scs_Mea_Empiric_Value[N-1]; 10000 To 200000 Numbers (N) Of The Mean Value Memory, See Channel-Specific Sd 55625 $Scs_Mea_Average_Value[N-1] - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
3.1 Overview of measuring cycle parameters
No. Screen form Cycle
parameters parameters
S_MA
14 X
15 Measuremen S_NMSP
ts
16 TR S_TNAME
17 DL S_DLNUM
18 TZL S_TZL
S_TDIF
19 DIF
20 TUL S_TUL
21 TLL S_TLL
S_TMV
22 TMV
S_K
23 FW
24 S_EVNUM
25 S_MCBIT
_DMODE
26
27 _AMODE
All default values = 0 or marked as the range of values a to b
1)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
2)
Only for offset in tool, otherwise parameter = ""
3)
Only for offset in tool and dimensional tolerance "Yes", otherwise parameter = 0
4)

Only if the "Setup additive offset" function has been set-up in the general MD 18108 $MN_MM_NUM_SUMCORR . In

5)
addition, in the general MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK , bit8 must be set to 1.
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
6)
Diameter or width of the protection zone within a hole or groove
7)
Diameter or width of the protection zone outside of a spigot or rib
Empirical averaging possible for tool offset
8)

Value range for empirical mean value memory:

1 to 20 numbers (n) of the empirical value memory, see channel-specific SD 55623 $SCS_MEA_EMPIRIC_VALUE[n-1]

10000 to 200000 numbers (n) of the mean value memory, see channel-specific SD 55625
$SCS_MEA_AVERAGE_VALUE[n-1]
234
Meaning
Number of the measuring axis
UNITS position)
Values: 1 = 1st axis of the plane (for G17 X)
2 = 2nd axis of the plane (for G17 Y)
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
2), 4)
Dimensional difference check
Upper tolerance limit
4)
Lower tolerance limit
4)
Offset range for averaging
Weighting factor for averaging
Data set, empirical mean value memory
Reserved
Display mode
Values: UNITS: Machining plane G17/G18/G19

0 = Compatibility, the plane active before the cycle call remains active

1 = G17 (only active in the cycle)

2 = G18 (only active in the cycle)

3 = G19 (only active in the cycle)

Alternative mode
Values: UNITS: Dimensional tolerance yes/no
0 = No

1 = Yes

(only for measurement of groove or rib, see
7)
(value range 1 to 9)
2)
5)
2), 4)
2)
2)
2), 8)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
BMVAR
Measuring cycles