Siemens SINUMERIK 840D sl Programming Manual page 245

No. Screen form Cycle
parameters parameters
2 S_TC
3 Icon+ S_PRNUM
number
4 S_SETV
S_STA1
5 Alpha 0
6 Alpha 0 S_SETV0
7 Alpha 1 S_SETV1
8 XN S_SETV2
S_SETV3
9 XN
10 Delta S_SETV4
11 Delta S_SETV5
12 Alpha 2 S_TNVL
13 DFA S_FA
14 TSA S_TSA
15 Measureme S_NMSP
nts
16 S_MCBIT
17 _DMODE
18 _AMODE
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
TEN MILLION: Log file
0 = no protocol file
1 = protocol file with the calculated vectors (tool carrier) and the 1st dynamic
5-axis transformation (TRAORI(1)), if set-up in MDs.
Number of the swivel data record (tool carrier)
Number of the field of the probe parameters (not probe number)
(default=1)
Diameter of the calibration ball
Starting angle for measurement at an angle
Position value of rotary axis 1 (if rotary axis is manual or semi-automatic)
Position value of rotary axis 2 (if rotary axis is manual or semi-automatic)
Position value for normalizing rotary axis 1
Position value for normalizing of rotary axis 2
Tolerance value of the offset vectors I1 to I4
Tolerance value of rotary axis vectors V1 and V2
Limit value for distortion of the triangle (value range 1 to 60 degrees)
(default=20)
7)
Measurement path
Safe area
Number of measurements at the same location
Reserved
Display mode
Values: UNITS: Machining plane G17/G18/G19
0 = compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
Values: UNITS: Tolerance check yes/no
0 = No
1 = Yes: Evaluation of the tolerance values of the vectors
TENS: Acknowledgment by the operator when entering the calculated
vectors in the swivel data set
0 = yes Operator must acknowledge the change
1 = no: calculated vectors are entered immediately (only effective if
HUNDREDS and THOUSANDS position = 0)
HUNDREDS: Measurement result display
0 = No
1 = Yes
THOUSANDS: Measurement result display can be edited
0 = no
1 = yes, and can be edited (only effective, if the HUNDREDS position = 1)
3.1 Overview of measuring cycle parameters
6)
(default=1)
2)
4)
5)
Parameter lists
6)
,
S_SETV4 S_SETV5
245