Siemens SINUMERIK 840D sl Programming Manual page 99

List of the result parameters
The measuring variant "Set edge" provides the following result parameters:
Table 2- 13
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVR [21]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Set edge" result parameters
Description
Setpoint value for measuring axis
Setpoint in 1st axis of the plane → only for
Setpoint in 2nd axis of the plane → only for
Setpoint in 3rd axis of the plane → only for
Actual value for measuring axis
Actual value in 1st axis of the plane → only for
Actual value in 2nd axis of the plane → only for
Actual value in 3rd axis of the plane → only for
Difference for measuring axis
Difference in 1st axis of the plane → only for
Difference in 2nd axis of the plane → only for
Difference in 3rd axis of the plane → only for
Mean value
D number or WO number
Measuring cycle number
Measuring version
Tool name
Measuring variants
2.3 Measure workpiece (milling)
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
99