Parameter Lists; Overview Of Measuring Cycle Parameters; Cycle973 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists

3.1

Overview of measuring cycle parameters

3.1.1

CYCLE973 measuring cycle parameters

PROC CYCLE973(INT S_MVAR,INT S_PRNUM,INT S_CALNUM,REAL S_SETV,INT S_MA,INT S_MD,REAL
S_FA,REAL S_TSA,REAL S_VMS,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE) SAVE ACTBLOCNO
DISPLOF
Table 3- 1 CYCLE973 call parameters
No. Screen form Cycle
parameters parameters
1 S_MVAR
2 Icon+ S_PRNUM
number
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
1)
Meaning
Measuring variant (default=0012103)
Values: UNITS: Calibration on a surface, edge or in a groove
0 = Length on surface/edge (in the WCS) with known setpoint
1 = Radius on surface (in the WCS) with known setpoint
2 = Length in groove (in the WCS), see
3 = Radius in groove (in the WCS), see
TENS: Reserved
0 = 0
HUNDREDS: Reserved
1 = 1
THOUSANDS: Selection of measuring axis and measuring direction for
calibration
2)
0 = No specification (for surface calibration on the groove bottom, no selection
of the measuring axis and measuring direction)
1 = Specify selection of measuring axis and measuring direction, see
(one measuring direction in a measuring axis)
S_MD
2 = Specify selection of measuring axis, see
a measuring axis)
TEN THOUSANDS: Determination of the positional deviation (probe skew)
0 = Determine positional deviation
1 = Do not determine positional deviation
HUNDRED THOUSANDS: Reserved
0 = 0
MILLIONS: Determination of the tool length for calibration on a surface
0 = Do not determine tool length (only trigger points)
1 = Determine tool length
Number of the field of the probe parameters (not probe number)
(default=1)
S_CALNUM
S_CALNUM
4)
(two measuring directions in
S_MA
3
,
S_MA
2), 3)
215