Parameter lists
3.1 Overview of measuring cycle parameters
No. Screen form
Cycle
parameters
parameters
S_EVNUM
19
EVN
20
21
22
1)
2)
Correction in WO only possible for measurement without reversal
3)
For tool offset in the channel-specific MD 20360 TOOL_PARAMETER_DEF_MASK , observe bit0 and bit1
4)
5)
addition, in the general MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK , bit8 must be set to 1.
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
6)
Empirical averaging only possible for tool offset
7)
220
Meaning
Number of the empirical mean value memory
Reserved
Display mode
Alternative mode
0 = No
2), 7)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measuring cycles