Siemens SINUMERIK 840D sl Programming Manual page 180

Measuring variants
2.4 Measure tool (turning)
Figure 2-21
①
②
Procedure
The part program or ShopTurn program to be processed has been created and you are in
the editor.
Parameters
G code program
Parameters Description
Calibration data set (1 - 6)
F Calibration and measuring
feedrate
180
1
Position after the end of the measuring cycle, example, 1st axis of the plane (for G18: Z)
Trigger point of the 1st measuring axis in the positive direction (general SD 54626)
Trigger point of the 1st measuring axis in the negative direction (general SD 54625)
1. Press the "Meas. tool" softkey.
2. Press the "Calibrate probe" softkey.
The input window "Calibrate: probe" is opened.
Unit
-
Distance/
min
2
ShopTurn program
Parameters Description
T Name of the calibration tool
D Cutting edge number (1 - 9)
Calibration data set (1 - 6)
F Calibration and measuring feedrate mm/min
β Tool alignment with swivel axis



V Tool orientation with a tool spindle
Z Start point Z of the measurement
X Start point X of the measurement
Y Start point Y of the measurement
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
(0 degrees)
(90 degrees)
Value entry
Unit
-
-
-
Degrees
Degrees
mm
mm
mm
Measuring cycles