JAI GO-5100MP-USB User Manual page 58

Item
p） ） AICustomControlPolarized
Polarize Image Selector
Panel1 Selector
Panel2 Selector
Panel3 Selector
Panel4 Selector
Reflection Adjust [%]
Item
q） ） AICustomControlMisc
VideoProcessBypassMode
Trigger Option
OptIn Filter Selector
Video Send Mode
Sensor LVDS Ch Num
Sensor Digitization Bits
Setting range
Raw Image, Raw Image
Four Polarize Element,
Four Functions,
Color on Picture,
Color on Gray
Polarize Angle, ー
Polarize Ratio,
Diffused Light,
Polarized Light,
Average Light
Polarize Angle, ー
Polarize Ratio,
Diffused Light,
Polarized Light,
Average Light
Polarize Angle, ー
Polarize Ratio,
Diffused Light,
Polarized Light,
Average Light
Polarize Angle, ー
Polarize Ratio,
Diffused Light,
Polarized Light,
Average Light
50 〜 200 % step 10 100
Setting range
Off, On Off
Off Off
10μs,
100μs,
500μs,
1ms,
5ms,
10ms
Normal Mode, Normal Mode
Trigger Sequencer Mode,
Command Sequencer Mode
8 8
10Bits, 12Bits 10Bits
— 58 —
Default value
Configure controling polarization settings.
Set the video output mode.
This mode allows you to set the image to
output by assigning any of the following
five information items to each area of the
screen divided into four.
The five information items are as follows.
PolarizeAngle,
PolarizeRatio,
DiffusedLight,
PolarizedLight,
AverageLight
Panel 1 to 4 show the 4 division positions
as shown below.
Panel1 Selector : top left
Panel2 Selector : top right
Panel3 Selector : bottom left
Panel4 Selector : bottom right
The ratio for removing the polarized light
component can be changed by adjusting
Reflection Adjust.
If ReflectionAdjust is set higher, DiffusedLight with
more of the polarized light component removed can
be obtained.
Default value
Configure settings for other JAI functions.
Enable/disable VideoProcessBypass mode.
Select the surge protection filter
Display the [VideoSendMode].
Display the number of sensor output LVDS
channels.
Display the resolution per pixel of sensor
output.
GO-5100MP-USB
Description
Description