JAI GO-5100MP-USB User Manual page 50

Item
e） ） Digital I/O contr
Line Selector
Line Mode
Line Inverter
Line Status
Line Source
Line Format
Line Status All
User Output Selector
User Output Value
Setting range
Line2-Opt Out 1, Line2-Opt Out 1
Line3-Opt Out 2,
Line5-Opt In 1,
Time Stamp Reset,
NAND Gate 0 In 1,
NAND Gate 0 In 2,
NAND Gate 1 In 1,
NAND Gate 1 In 2
Input, Output ー
True, False False
True, False ー
Low, Low
High,
Acquisitiion Trigger Wait,
Acquisition Active,
Frame Trigger Wait,
Frame Active,
Exposure Active,
FVAL,
LVAL,
PulseGenerator0,
User Output 0,
User Output 1,
Line5 - Opt In 1,
NAND0Out,
NAND1Out,
ー Opto Coupled
ー 0x00
User Output 0 User Output 0
User Output 1
True, False False
— 50 —
Default value
Configure settings for digital input/output.
Select the input/output to configure.
Display the input/output status (whether it
is input or output).
Enable/disable polarity inversion for the
selected input signal or output signal.
Display the status of the input signal or
output signal (True: High, False: Low).
Select the line source signal for the item
selected in [LineSelector].
Display the signal format.
Display the input/output signal status.
The state is shown with 16 bits. Bit
assignments are as follows.
[0] 0] (unus
[1] 1] Line2 - OptO
[2] 2] Line3 - OptO
[3] ] (unus
[4] 4] Line5 - Opt I
[5], [6], [7], [8], [9], [10] (unused)
[11] 11] Time Stamp R
[12] 12] NAND Gate 0
[13] 13] NAND Gate 0
[14] 14] NAND Gate 1
[15] 15] NAND Gate 1
Set the UserOutput signal.
Set the value for the UserOutput selected
in [UserOutputSelector].
GO-5100MP-USB
Description