JAI GO-5100MP-USB User Manual page 49

Item
c） ） cquisition Control
Acquisition Mode
Acquisition Start
Acquisition Stop
AcquisitionFrameCount
AcquisitionFrameRate(Hz)
Trigger Selector
Trigger Mode
Trigger Software
Trigger Source
Trigger Activation
Trigger Overlap
ExposureMode
ExposureTime
ExposureAuto
Item
d） ） nalog Control
Gain Selector
Gain
Black Level Selector
Black Level
GainAuto
Setting range
Single Frame, Countinuous
Multi Frame,
Continuous
ー ー
ー ー
1〜255 1
0.125〜74.0192 74.0192
Acquisition Start, Frame Start
Acquisition End,
Frame Start,
Acquisition Transfer Start
Off, On Off
ー ー
Low Line 5 - Optical In 1
High
Software
Pulse Generator0
User Output 0
User Output 1
Line5 - Optical In 1
NAND0Out
NAND1Out
Rising Edge Rising Edge
Falling Edge
Off, ReadOut Off
Off, Timed, Timed
Trigger Width
1 〜 ー
Off, Continuous Off
Setting range
Analog All Analog All
x1.0 〜 x16.0 x1.0
Digital All Digital All
-133〜255 0
Off, Off
Continuous
— 49 —
Default value
Configure image capture settings.
Select the image capture mode.
Start image capture.
Stop image capture.
In [MultiFrame] mode, set the number of
frames to capture.
Set the frame rate as a frequency. (unit:
Hz)
The maximum value varies depending on
the PixelFormat and ROI settings.
Select the trigger operation.
Select the trigger mode.
Execute a software trigger.
Select the trigger signal source.
Select the polarity of the trigger signal
(i.e., location of signal at which trigger is applied).
Select the trigger overlap operation.
Select the exposure mode.
Set the exposure time. The specifiable
range varies depending on the
[StartTriggerMode] and
[PixelFormat] setting.
Set whether to enable auto exposure.
Default value
Configure analog control settings.
Select the gain to configure.
Set the gain value for the gain setting
selected in [GainSelector].
Select the black level to configure.
Set the black level value.
Enable/disable gain auto adjustment.
[Once] automatically changes to [Off]
when the signal level converges once.
GO-5100MP-USB
Description
Description