JAI GO-5100MP-USB User Manual page 54

Item
l） PulseGenerator
Clock Pre Scaler
Pulse Generator Clock (MHz)
Pulse Generator Selector
Pulse Generator Length
Pulse Generator Length (ms)
Pulse GeneratorFrequency (Hz) 0.429154〜450000
Pulse Generator Start Point
Pulse Generator Start Point
(ms)
Pulse Generator End Point
Pulse Generator End Point (ms)
Pulse Generator Pulse Width
(ms)
Pulse Generator Repeat Count
Setting range
1〜4096 165
0.018127〜74.25 0.45
Pulse Generator 0 Pulse Generator 0
1〜1048575 30000
0.00222222〜2330.17 66.6667
15
0 〜 1048575 0
0.002222〜2330.166666 0
1 〜 1048575 15000
0.002222〜2330.166666 33.3333
0.002222〜2330.166666 33.3333
0 〜 255 0
— 54 —
Default value
Configure pulse generator settings.
Set the division value for the prescaler (12
bit) using PixelClock as the base clock.
Set the clock used for the pulse generator.
This value is calculated using the
[ClockPreScaler] value as a base.
Select the pulse generator.
Set the maximum count-up value as a
clock count.
Set the maximum count-up value in
milliseconds.
This value is calculated using the
[PulseGeneratorLength] value as a base.
The setting range varies depending on the
[ClockPreScaler] value.
Set the maximum count-up value as a
frequency.
This value is calculated using the
[PulseGeneratorLength] value as a base.
Set the start point of the High interval as a
clock count. When the counter reaches this
value, the output will be 1.
Set the start point of the High interval in
milliseconds.
When the counter reaches this value, the output will
be 1.
The setting range varies depending on the
[ClockPreScaler] value.
Set the start point of the Low interval as a
clock count.
When the counter reaches this value, the output will
be 0.
Set the start point of the Low interval in
milliseconds.
When the counter reaches this value, the output will
be 0.
The setting range varies depending on the
[ClockPreScaler] value.
Display the High interval width of the pulse
in milliseconds.
The duration between the Start Point and End Point is
calculated. The setting range varies depending on the
[ClockPreScaler] value.
Set the repeat count for the counter.
When this is set to [0], a free counter is enabled with
no repeat limit.
GO-5100MP-USB
Description