JAI GO-5100MP-USB User Manual page 51

項⽬
f） ） ounter And Timer Control
Counter0 Event Source
Counter0 Event Activation
Counter0 Reset
Counter0 Refresh
Counter0 Value
Counter0 Status
Counter1 Event Source
Counter1 Event Activation
Counter1 Reset
Counter1 Refresh
Counter1 Value
Counter1 Status
Counter2 Event Source
Counter2 Event Activation
Counter2 Reset
Counter2 Refresh
Counter2 Value
Counter2 Status
Item
g） User Set Control
User Set Selector
User Set Load
User Set Save
設定範囲
Off, Off
Frame Trigger,
Frame Start,
Exposure Start,
Frame Transfer End
Rising Edge ー
Falling Edge
ー ー
ー ー
ー 0
Counter Active Counter Active
Off, Off
Frame Trigger,
Frame Start,
Exposure Start,
Frame Transfer End
Rising Edge ー
Falling Edge
ー ー
ー ー
ー 0
Counter Active Counter Active
Off, Off
Frame Trigger,
Frame Start,
Exposure Start,
Frame Transfer End
Rising Edge ー
Falling Edge
ー ー
ー ー
ー 0
Counter Active Counter Active
Setting range
Default, Default
UserSet1,
UserSet2,
UserSet3
0(default), 1, 2, 3 ー
1,2,3 ー
— 51 —
初期値
Configure counter settings.
(This camera only supports counter functions.)
Assign the counter event signal for which
you want to read the count value to a
dedicated counter, and read the value.
Set the count timing.
Reset the counter.
Update the count value.
Display the count value.
Display the counter status.
CounterIdle: Idle
CounterActive: Counting
CounterOverflow: Count value exceeded the
Assign the counter event signal for which
you want to read the count value to a
dedicated counter, and read the value.
Set the count timing.
Reset the counter.
Update the count value.
Display the count value.
Display the counter status.
CounterIdle: Idle
CounterActive: Counting
CounterOverflow: Count value exceeded the
Assign the counter event signal for which
you want to read the count value to a
dedicated counter, and read the value.
Set the count timing.
Reset the counter.
Update the count value.
Display the count value.
Display the counter status.
CounterIdle: Idle
CounterActive: Counting
CounterOverflow: Count value exceeded the
Default value
Configure user settings.
Select the user settings.
Load user settings.
(If 0 is specified, the factory default setting is read.)
Save the current setting values as user
settings.
GO-5100MP-USB
説明
mazimum value
mazimum value
mazimum value
Description