Table of Contents
Advertisement
6.8 FLASH MESSAGES
SS OUT OF RANGE –
SS VALUE NOT STORED
SS PLEASE ENTER A
SS NON-ZERO PASSCODE
SS PRESS [ENTER] TO
SS ADD AS DEFAULT
SS PRESS [ENTER] TO
SS BEGIN TEXT EDIT
SS PRESS [ENTER] TO
SS REMOVE MESSAGE
SS PRESSED KEY
SS IS INVALID HERE
SS RESETTING LATCHED
SS CONDITIONS
SS SETPOINT ACCESS
6
SS DENIED (PASSCODE)
SS SETPOINT ACCESS
SS DENIED (SWITCH)
SS SETPOINT ACCESS
SS IS NOW ALLOWED
SS SETPOINT ACCESS
SS IS NOW RESTRICTED
SS INVALID SERIAL
SS NUMBER
SS PASSCODE VALID -
SS OPTIONS ADJUSTED
6-24
This flash message is displayed in response to pressing
setpoint message with a numerical value. The edited value was either less
than the minimum or greater than the maximum acceptable value for this
setpoint and, as a result, was not stored.
This flash message is displayed while changing the passcode from the
setpoint S1 745 SETUP/PASSCODE/CHANGE PASSCODE. An attempt was made to
change the passcode to 0 when it was already 0.
This flash message is displayed for 5 seconds in response to pressing the
decimal key followed by
E N TE R
message except the S1 745 SETUP/DEFAULT MESSAGES/SELECTED DEFAULTS
setpoints. Pressing
E N TE R
setpoint or actual value message to the default list.
This flash message is displayed in response to pressing
while on a setpoint message with a text entry value. The
V AL U E
key must first be pressed to begin editing.
This flash message is displayed for 5 seconds in response to pressing the
decimal key followed by
messages in S1 745 SETUP/DEFAULT MESSAGES/SELECTED DEFAULTS. Pressing
again while this message is displayed removes the default message
E N TE R
from the list.
This flash message is displayed in response to any pressed key that has no
meaning in the current context.
This flash message is displayed in response to pressing
relay is in local mode. All active targets for which the activating condition is
no longer present will be cleared.
This flash message is displayed in response to pressing
setpoint message. Setpoint access is restricted because the programmed
passcode has not been entered to allow access.
This flash message is displayed in response to pressing
setpoint message. Setpoint access is restricted because the setpoint access
terminals have not been connected.
This flash message is displayed in response to entering the programmed
passcode at the S1 745 SETUP/PASSCODE/ALLOW SETPOINT WRITE ACCESS
setpoint. The command to allow write access to setpoints has been
successfully executed and setpoints can be changed and entered.
This flash message is displayed in response to correctly entering the
programmed passcode at S1 745 SETUP/PASSCODE/RESTRICT SETPOINT WRITE
ACCESS?. The command to restrict access to setpoints has been successfully
executed and setpoints cannot be changed.
This flash message is displayed when an attempt is made to upgrade
installed options and the 745 detects an invalid serial number.
This flash message is displayed when an attempt to upgrade an option was
successful.
745 Transformer Management Relay
while displaying any setpoint or actual value
again while this message is displayed adds the
while displaying one of the selected default
E N TE R
6 ACTUAL VALUES
while on a
E N TE R
or
V AL U E
E N TE R
when the
R E S ET
while on any
E N TE R
while on any
E N TE R
GE Power Management
Advertisement
Table of Contents
