Appendix B Approvals - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Appendix B Approvals

This chapter lists the approval for ET 200SP CM 1xDALI specifically.
Detailed references to the other approvals of CM 1xDALI are listed in the document
200SP Distributed I/O system.
Note
Information of the ET 200SP CM 1xDALI
The currently valid markings and approvals are printed on the components of the ET 200SP
CM 1xDALI.
DALI-2
The CM 1xDALI meets the requirements of the DALI-2 standards.
IECEx
The CM 1xDALI meets the requirements of explosion protection according to
IECEx. IECEx classification: Ex nA IIC T4 Gc
IECEx certificate: IECEx DEK 19.0024X
The CP meets the requirements of the following standards:
● IEC 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
ATEX
The CP meets the requirements of the EC directive 2014/34/EU "Equipment and Protective
Devices for Use in Potentially Explosive Atmospheres".
Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
116
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
B
ET
Manual, 06/2019, A5E46959434-AA