Dali_Sensor_Query_Dev_Param - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Programming
5.7 Configuration function blocks
5.7.13

DALI_SENSOR_QUERY_DEV_PARAM

Description
DALI_SENSOR_QUERY_DEV_PARAM is used for querying the device parameters of the
input device (sensor).
● When you set the input "PHY_DEV" to 1, this function block queries the parameters from
the physical device (refer to data flow path 6 (Page 23)).
● When you set the input "PHY_DEV" to 0, this function block queries the parameters which
are saved in CM 1xDALI (refer to data flow path 2 (Page 23)).
You can set the device parameters of sensor by using DALI_SENSOR_SET_DEV_PARAM
(Page 93).
Parameter
The following table shows the parameters of the function block:
Parameter Declaration
QUERY Input
ADDRES
S
PHY_DEV
CM_DALI InOut
92
Data type Memory
area
BOOL I, Q, M, D, Query device parameters of the sensor upon a rising edge.
L or Con-
stant
USInt I, Q, M, D, Specify the short address of the device.
L or Con-
Range: 0 to 63
stant
BOOL I, Q, M, D, Specify the location of parameters.
L or Con-
•
stant
•
"DALI_CT The data block of DALI_CTRL specifies the CM 1xDALI which com-
RL" municates with the current function block.
PHY_DEV = 1 : Query the parameters from the physical device by
sending commands.
PHY_DEV = 0 : Query the parameters which are saved in CM
1xDALI.
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Description
Manual, 06/2019, A5E46959434-AA