Siemens SIMATIC ET 200SP CM 1xDALI Manual page 67

Programming
5.6 Diagnostic function blocks
Parameter
The following table shows the parameters of the function block:
Parameter Declaration
CHECK Input
STATUS_
MASK
CM_DALI InOut
BUSY Output
ACTIVE
DONE
ERROR
STATUS
MATCH
66
Data type Memory
area
BOOL I, Q, M, D, Compare the specified status mask with sensors upon a rising edge.
L or Con-
stant
Ar- I, Q, M, D, Show the status mask of all the sensors.
ray[0..63] L or Con-
of BYTE stant
"DALI_CT The data block of DALI_CTRL specifies the CM 1xDALI which com-
RL" municates with the current function block.
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BYTE I, Q, M, D, When ERROR = 0, STATUS has
L following three values:
•
•
•
Ar- I, Q, M, D, Check result of devices on all the short addresses.
ray[0..63] L
MATCH = 1: The status of the sensor which is matched with the speci-
of BOOL
fied status mask.
The index of the array indicates the short address.
BUSY = 0: Processing of job is terminated.
BUSY = 1: Job is still being committed.
ACTIVE = 0: Job is not yet started.
ACTIVE = 1: Job is being executed.
DONE = 0: Job is not yet started or still executing.
DONE = 1: Job is executed without errors.
ERROR = 0: No error occurs.
ERROR = 1: Error occurs during processing.
16#00: Idle
16#01: Executing
16#7F: Completed
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Description
When ERROR = 1, STATUS
shows the detailed error code. For
the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
Manual, 06/2019, A5E46959434-AA