Dali_Sensor_Status - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Programming
5.6 Diagnostic function blocks
Parameter
The following table shows the parameters of the function block:
Parameter Declaration
SET Input
ADDRES
S
OPHOUR
CM_DALI InOut
BUSY Output
ACTIVE
DONE
ERROR
STATUS
5.6.6

DALI_SENSOR_STATUS

Description
DALI_SENSOR_STATUS is used for querying the status of one sensor (input device). The
status information is queried from the physical DALI device (refer to data flow path 6
(Page 23)). The status information saved in CM 1xDALI will be updated (refer to data flow
path 4 (Page 23)).
60
Data type Memory
area
BOOL I, Q, M, D, Set the operation hour upon a rising edge.
L or Con-
stant
USInt I, Q, M, D, Specify the short address of the device.
L or Con-
Range: 0 to 63
stant
UInt I, Q, M, D, Set the operation hour to the control gear.
L or Con-
stant
"DALI_CT The data block of DALI_CTRL specifies the CM 1xDALI which com-
RL" municates with the current function block.
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BYTE I, Q, M, D, When ERROR = 0, STATUS has
L following three values:
•
•
•
BUSY = 0: Processing of job is terminated.
BUSY = 1: Job is still being committed.
ACTIVE = 0: Job is not yet started.
ACTIVE = 1: Job is being executed.
DONE = 0: Job is not yet started or still executing.
DONE = 1: Job is executed without errors.
ERROR = 0: No error occurs.
ERROR = 1: Error occurs during processing.
16#00: Idle
16#01: Executing
16#7F: Completed
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Description
When ERROR = 1, STATUS
shows the detailed error code. For
the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
Manual, 06/2019, A5E46959434-AA