Parameters; Parameter Assignment; Cm 1Xdali Module Parameters - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Parameters

4.1

Parameter assignment

Introduction
You configure and assign the parameters of the communication module with STEP 7 V15.1
or later versions.
In the CM 1xDALI project, you assign the parameters in the device view of STEP 7 and in
the properties tab of the communication module DALI.
4.2

CM 1xDALI Module Parameters

Module Parameters
Each CM 1xDALI has the following DALI parameters in Module Parameters. According to
your request, you can configure any of these parameters.
The following table shows the module parameters for the CM 1xDALI.
Table 4- 1 Module Parameters
Module Parameters
Basic parameter
Enable integrated
DALI bus power sup-
ply
Enable DALI Applica-
tion Controller
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
Description
Enable or disable the DALI bus power supply.
Enable: Use the integrated DALI bus power in the CM
•
1xDALI.
Disable: Do not use the integrated DALI bus power in
•
the CM 1xDALI.
Enable or disable DALI Application Controller.
Enable: The CM 1xDALI can send any forward frame
•
or receive any backward frame to the DALI bus.
Disable: The CM 1xDALI cannot send any forward
•
frame or receive any backward frame to the DALI bus.
Value range Default
value
Enable
Enable
•
Disable
•
Enable
Enable
•
Disable
•
4
Configura-
tion in
RUN
Yes
Yes
21