Dali_Ecg_Query_Group - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Programming
5.7 Configuration function blocks
5.7.7

DALI_ECG_QUERY_GROUP

Description
DALI_ECG_QUERY_GROUP is used for querying the group membership of DALI control
gears.
● When you set the input "PHY_DEV" to 1, this function block queries the group
membership from the physical device (refer to data flow path 6 (Page 23)).
● When you set the input "PHY_DEV" to 0, this function block queries the parameters which
are saved in CM 1xDALI (refer to data flow path 2 (Page 23)).
You can set the group membership of control gear by using DALI_ECG_SET_GROUP
(Page 83).
Parameter
The following table shows the parameters of the function block:
Parameter Declaration
QUERY Input
ADDRES
S
PHY_DEV
CM_DALI InOut
BUSY Output
ACTIVE
DONE
ERROR
82
Data type Memory
area
BOOL I, Q, M, D, Query the group membership of the control gear upon a rising edge.
L or Con-
stant
USInt I, Q, M, D, Specify the short address of the device.
L or Con-
Range: 0 to 63
stant
BOOL I, Q, M, D, Specify the location of parameters:
L or Con-
•
stant
•
"DALI_CT The data block of DALI_CTRL specifies the CM 1xDALI which com-
RL" municates with the current function block.
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
PHY_DEV = 0 : Query the parameters which are saved in CM
1xDALI.
PHY_DEV = 1 : Query the parameters from the physical device by
sending commands.
BUSY = 0: Processing of job is terminated.
BUSY = 1: Job is still being committed.
ACTIVE = 0: Job is not yet started.
ACTIVE = 1: Job is being executed.
DONE = 0: Job is not yet started or still executing.
DONE = 1: Job is executed without errors.
ERROR = 0: No error occurs.
ERROR = 1: Error occurs during processing.
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Description
Manual, 06/2019, A5E46959434-AA