Siemens SIMATIC ET 200SP CM 1xDALI Manual page 97

Programming
5.7 Configuration function blocks
Parameter Declaration
ACTIVE
DONE
ERROR
STATUS
INST_PRM_
QRY
INST_TY
PE
INST_AC
TIVE
EVENT_
SCHEM
E
EVENT_
FILTER
EVENT_
PRIO
TYPE_P
RM_QR
Y
1
For the detailed description of sensor instance type-related parameters, refer to the following table.
1
96
Data type Memory
area
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BYTE I, Q, M, D, When ERROR = 0, STATUS has
L following three values:
•
•
•
In- D, L The instance parameters of input device (sensor)
stPrmQry
Detail
USInt Refer to Instance type of input device (Page 107) to query the In-
stance type.
BOOL Activation of the instance.
USInt An instance of an input device uses the selected event source ad-
dressing according to the following scheme:
•
•
•
•
•
BYTE The event message filter is used to enable and disable specific
events. Refer to Description for EVENT_FILTER (Page 107) for
detailed description.
USInt The sending priority of the event message. The system reactions
are sent according to the set priority. The system reactions with
high priority take precedence over the system reactions with low
priority.
Array[0..6] The type-related parameters of the instance.
of BYTE
Description
ACTIVE = 0: Job is not yet started.
ACTIVE = 1: Job is being executed.
DONE = 0: Job is not yet started or still executing.
DONE = 1: Job is executed without errors.
ERROR = 0: No error occurs.
ERROR = 1: Error occurs during processing.
16#00: Idle
16#01: Executing
16#7F: Completed
0: Instance type and instance number
1: Short address and instance type
2: Short address and instance number
3: Device group and instance number
4: Instance group and instance type
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
When ERROR = 1, STATUS
shows the detailed error code.
For the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
Manual, 06/2019, A5E46959434-AA