Siemens SIMATIC ET 200SP CM 1xDALI Manual page 104

Parameter
The following table shows the parameters of the function block:
Parameter Declaration
DOWNLO Input
AD
DEV_TYP
E
ADDRES
S
CANCEL
CM_DALI InOut
BUSY Output
ACTIVE
DONE
ERROR
STATUS
For the detailed description of STATUS on download process, refer to the following table.
1
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
Data type Memory
area
BOOL I, Q, M, D, Download parameters from the device upon a rising edge.
L or Con-
stant
USInt I, Q, M, D, Select the device type:
L or Con-
•
stant
•
USInt I, Q, M, D, Specify the short address of the device.
L or Con-
Range: 0 to 63
stant
BOOL I, Q, M, D, CANCEL = 1: Stop this function block, and return an error.
L or Con-
stant
"DALI_CT The data block of DALI_CTRL specifies the CM 1xDALI which com-
RL" municates with the current function block.
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BOOL I, Q, M, D, Status parameter:
L
•
•
BYTE I, Q, M, D, When ERROR = 0, STATUS has
L following three values:
•
•
•
1: Control gear
2: Input device (Sensor)
BUSY = 0: Processing of job is terminated.
BUSY = 1: Job is still being committed.
ACTIVE = 0: Job is not yet started.
ACTIVE = 1: Job is being executed.
DONE = 0: Job is not yet started or still executing.
DONE = 1: Job is executed without errors.
ERROR = 0: No error occurs.
ERROR = 1: Error occurs during processing.
16#00: Idle
> 16#00 and < 16#7F: Down-
load progress
1
16#7F: Completed
5.7 Configuration function blocks
Description
When ERROR = 1, STATUS
shows the detailed error code. For
the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
Programming
103