Dali_Sensor_Set_Inst_Param - Siemens SIMATIC ET 200SP CM 1xDALI Manual

Table 5- 4 Sensor instance type-related parameters
Attributes BYTE Type 1 (push button)
Read/Write 0
1
2
3
Read only 4
5
6
5.7.16

DALI_SENSOR_SET_INST_PARAM

Description
DALI_SENSOR_INST_PARAM is used for setting the instance parameters of the input
device (sensor).
● If the status of the sensor is configured (for example, sensor is added by using
DALI_SENSOR_ADD (Page 89)), the parameters are saved in the CM 1xDALI (refer to
data flow path 1 (Page 23)) and sent to the physical device (refer to data flow path 5
(Page 23)).
● If the status of the sensor is not configured, the parameters are only sent to the physical
device (refer to data flow path 5 (Page 23)).
You can query the instance parameters of the sensor by using
DALI_SENSOR_QUERY_INST_PARAM (Page 95).
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
Type 2 (absolute input)
tShort
Deadtime
tDouble
Report time
tRepeat
tStuck
tShortMin
Type 3 (occupancy)
Hold time
Report time
Not used Deadtime
Resolution
Not used
5.7 Configuration function blocks
Type 4 (light sensor)
Hysteresis
Hysteresis min
Report time
Not used Deadtime
Not used
Programming
Not used
97