Configuring An Mgcp Inspection Policy Map For Additional Inspection Control - Cisco ASA Series Configuration Manual

MGCP Inspection

Configuring an MGCP Inspection Policy Map for Additional Inspection Control

If the network has multiple call agents and gateways for which the ASA has to open pinholes, create an
MGCP map. You can then apply the MGCP map when you enable MGCP inspection.
Procedure
To create an MGCP inspection policy map, enter the following command:
Step 1
hostname(config)# policy-map type inspect mgcp map_name
hostname(config-pmap)#
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
Step 2 (Optional) To add a description to the policy map, enter the following command:
hostname(config-pmap)# description string
Step 3 Enter parameters configuration mode.
hostname(config-pmap)# parameters
hostname(config-pmap-p)#
Set one or more parameters. You can set the following options; use the no form of the command to
Step 4
disable the option.
•
•
•
Example
The following example shows how to define an MGCP map:
hostname(config)# policy-map type inspect mgcp sample_map
hostname(config-pmap)# parameters
hostname(config-pmap-p)# call-agent 10.10.11.5 101
hostname(config-pmap-p)# call-agent 10.10.11.6 101
hostname(config-pmap-p)# call-agent 10.10.11.7 102
hostname(config-pmap-p)# call-agent 10.10.11.8 102
hostname(config-pmap-p)# gateway 10.10.10.115 101
Cisco ASA Series Firewall CLI Configuration Guide
14-14
call-agent ip_address group_id—Configures the call agent groups that can manage one or more
gateways. The call agent group information is used to open connections for the call agents in the
group (other than the one a gateway sends a command to) so that any of the call agents can send the
response. Call agents with the same group_id belong to the same group. A call agent may belong to
more than one group. The group_id option is a number from 0 to 4294967295. The ip_address
option specifies the IP address of the call agent.
MGCP call agents send AUEP messages to determine if MGCP end points are present. This
Note
establishes a flow through the ASA and allows MGCP end points to register with the call
agent.
gateway ip_address group_id—Identifies which group of call agents is managing a particular
gateway. The IP address of the gateway is specified with the ip_address option. The group_id option
is a number from 0 to 4294967295 that must correspond with the group_id of the call agents that are
managing the gateway. A gateway may only belong to one group.
command-queue command_limit—Sets the maximum number of commands allowed in the MGCP
command queue, from 1 to 2147483647. The default is 200.
Chapter 14 Inspection for Voice and Video Protocols