4 How to Install
4.6.22 Electrical Installation, Control Terminals
To connect the cable to the terminal:
1.
Strip insulation by about 0.34–0.39 in [9–10 mm]
2.
Insert a screwdriver
3.
Insert the cable in the adjacent circular hole.
4.
Remove the screwdriver. The cable is now mounted in the terminal.
To remove the cable from the terminal:
1.
Insert a screwdriver
2.
Pull out the cable.
4
1)
Max. 0.015 x 0.1 in. [0.4 x 2.5 mm]
1.
4-54
1)
in the square hole.
1)
in the square hole.
MG.20.T1.22 - VLT
VLT AQUA Low Harmonic Drive Instruction
2.
®
is a registered Danfoss trademark
Manual
3.