Danfoss VLT AQUA Instruction page 91

VLT AQUA Low Harmonic Drive Instruction
Manual
5.1.13 PC software tools
PC-based Configuration Tool MCT 10
The low harmonic drive is equipped with two serial communication ports. Danfoss provides a PC tool for communication between PC and adjustable
frequency drive, PC-based Configuration Tool MCT 10. Please check the section on
MCT 10 set-up software
MCT 10 has been designed as an easy to use interactive tool for setting parameters in our adjustable frequency drives. The software can be downloaded
http://www.
from the Danfoss internet site
The MCT 10 set-up software will be useful for:
• Planning a communication network off-line. MCT 10 contains a complete adjustable frequency drive database
• Commissioning adjustable frequency drives on-line.
• Saving settings for all adjustable frequency drives.
• Replacing an adjustable frequency drive in a network.
• Simple and accurate documentation of adjustable frequency drive settings after commissioning.
• Expanding an existing network
• Adjustable frequency drives developed in the future will be fully supported.
MCT 10 set-up software supports Profibus DP-V1 via a master class 2 connection. This makes it possible to access on-line read/write parameters in an
adjustable frequency drive via the Profibus network. This will eliminate the need for an extra communication network.
Save adjustable frequency drive settings:
1. Connect a PC to the unit via USB com port. (NOTE: Use a PC, which is isolated from the line power, in conjunction with the USB port. Failure to
do so may damage equipment.)
2. Open MCT 10 Set-up Software
3. Choose "Read from drive"
4. Choose "Save as"
All parameters are now stored on the PC.
Load adjustable frequency drive settings:
1. Connect a PC to the adjustable frequency drive via the USB com port
2. Open MCT 10 Set-up software
3. Choose "Open"– stored files will be shown.
4. Open the appropriate file
5. Choose "Write to drive"
All parameter settings are now transferred to the adjustable frequency drive.
A separate manual for MCT 10 Set-up Software is available
.com/BusinessAreas/DrivesSolutions/Softwaredownload/DDPC+Software+Program.htm
Danfoss
: MG.10.Rx.yy
.
®
MG.20.T1.22 - VLT is a registered Danfoss trademark
5 How to Operate the Low Harmonic Drive
Available Literature
for detailed information on this tool.
.
5
5-11