Download  Print this page

Printer Does Not Print - Canon GM2000 Series Online Manual

Hide thumbs

Advertisement

Printer Does Not Print

Make sure printer is turned on.
Check1
If not, make sure the printer is securely plugged in and press ON button to turn on.
The ON lamp flashes while the printer is initializing. Wait until the ON lamp stops flashing and remains lit.
Note
• If you are printing large data, printing may take longer to start. The ON lamp flashes while the computer is
processing data and sending it to the printer. Wait until printing starts.
Make sure printer is properly connected to computer.
Check2
If you are using a USB cable, make sure it is securely connected to both the printer and the computer. When the
USB cable is securely plugged in, check the following:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device. Contact
the vendor of the relay device.
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If you use the printer over a LAN, make sure the printer is correctly set up for network use.
Cannot Find Printer while Using Wi-Fi
Cannot Find Printer while Using Wired LAN
Note
• Using IJ Network Device Setup Utility allows you to diagnose or repair network connection.
Select the link below to download IJ Network Device Setup Utility and install it.
Checking Printer Connection Status Using IJ Network Device Setup Utility
See below for starting up IJ Network Device Setup Utility.
Starting Up IJ Network Device Setup Utility
If printing from a computer, delete unnecessary print jobs.
Check3
Deleting the Undesired Print Job
Is your printer's printer driver selected when printing?
Check4
The printer will not print properly if you are using a printer driver for a different printer.
Make sure "Canon XXX series" (where "XXX" is your printer's name) is selected in the Print dialog box.
283

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: