Control; Control Via Contacts - BONFIGLIOLI Vectron ACTIVE Manual

9.1

9.1.1 Control via Contacts

In the operation mode "Control via Contacts" (
inverter is addressed via the digital inputs S1IND ... S6IND, the multifunction input
MFI1D as well as the additional inputs EM-S1IND ... EM-S3IND (optional expansion
modules).
The function of these inputs is described in the frequency inverter operating instruc-
tions and the expansion module operating instructions.
Note:
Sequence in Statemachine:
The numbers indicated in the individual operating statuses (e.g. 0x23) signal the
corresponding feedback (e.g. switched on) via the status word (bit 0...6).
50
50

Control

If the frequency inverter is addressed via digital inputs S1IND ... S6IND,
Control Word
addressing via the
Power-On
Initialization
Switched On
0x23
Release Release
On Off
Operation
released
0x27
Modbus Instruction manual
Modbus Instruction manual
Local/Remote
412 = 0), the frequency
410 is not used in this operation mode.
Fault
Acknowledge
from any
Fault
0x08
status
05/08
05/08