EMI Compliance
Certifications
Wiring the 2706-P42C2-SC and 2706-P44C2-SC Displays
WARNING
WARNING
Appendix B: Installing InView Marquee 2706-P4xC2-SC Message Displays B-5
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with installation guidelines, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will
be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Certifications are:
•
UL 60950-1, 2nd Edition Information Technology Equipment – Safety –
Part 1: General Requirements
•
CSA C22.2 No. 60950-1, 2
– Safety – Part 1: General Requirements
•
EN 60950-1:2006/A11:2009/A1:2010/A12:2011/A2:2013
•
IEC 60950-1:2005 (Second Edition) + Am 1:2009 + Am 2:2013
Hazardous voltage.
Contact with high voltage may cause death or serious injury.
Always disconnect power to the InView display prior to servicing.
Maintain separation of circuits.
Route the incoming power directly to the power connections terminal
block.
Do not run the power wiring over the logic board.
Tension dangereuse.
Toucher un câble a haute tension peut provoquer la mort ou des
blessures graves.
Sortir la prise d'alimentation de l'afficheur avant de le réparer.
Maintenir la séparation des câbles.
Brancher le câble d'alimentation directement au bornier d'alimentation
électrique.
Ne pas faire cheminer le câble d'alimentation le long de la carte.
nd
Edition Information Technology Equipment
User's Manual 0300277-02 Rev. D
Need help?
Do you have a question about the InView Series and is the answer not in the manual?
Questions and answers