Table of Contents
Advertisement
Plasterboard wall with plastered finish
(wall flush with front of fire only)
Note: Any wall linings that extend beyond the
front face of the fire MUST BE rated non-combustible.
Refer drawings about thick wall linings and
recess installations for details.
Adhesive is recommended in place
of screws as permanent fixing across
the top of the appliance
Plaster board
Plaster finish
Wallboard cutout A
Wallboard edge finished
(not a Rinnai supplied part)
A
Wallboard support rail
A (1 : 1)
13 mm
board
20 mm
setting for
Lips
combustible
options
Note: Wallboard support rails, the tabs for 10 mm and 13 mm boards
need to be trimmed off as indicated. If not using the optional Outer
Finishing Trim around the edge of the wallboard, then the latches can
be snapped off, otherwise the wallboard support rails and wallboard will
need to have clearance applied to fit.
No combustible
materials within
50mm of top of fire
Wallboard support rail MUST
be used for combustible wallboard and is
designed for wallboard thicknesses of 10,
13, and 20 mm allowing for 1 mm setback
for the Finishing Trim or plaster finish
Wallboard cut out A
10 mm board
Wallboard
Support
Linear installation guide 13563-H 08-19 | 31
Advertisement
Table of Contents
