Pentair Everpure Conserv HE-3 Original Instructions Manual page 26

To enable remote monitoring on this unit, a customer ID and
location number must be entered.
On the Store Settings menu, press the Customer Number
button to enter the customer's ID number and location
number. These are supplied by Pentair Everpure.
NOTE: The fields must be green to enter numbers.
Contact Pentair Everpure
®
customer ID and location number.
When the HE-3 is connected with the Pentair CES-9100TS
E-30C, the HE-3 will sense low salt and no salt conditions
from the softener. On the Store Settings Menu, press the
Softener In Use button to enter a Yes or No setting.
To have connectivity beween the Everpure® Conserv® HE-3
RO System and the CES-9100TS E-30C Softener, a phone
cord (Type 4 pin RJ11, not provided with the system) must be
connected between the RO system and the softener.
NOTE: Only the Pentair CES-9100TS E-30C Water Softener
may be used with the Pentair Everpure Conserv
HE-3 Controller.
On the System Settings Menu, pressing the Air Purge/Flush
Menu button will provide four (4) selections: Perform Air
Purge, Perform Tank Fill, Perform RO Flush and Perform RO
Rinse.
Selecting Perform Air Purge will fill the Storage Tank and
force air out. This cycle is based on tank level settings
entered in the System Settings Menu.
Selecting the Perform RO Flush will begin a flush cycle. The
flush will push RO water from the storage tank into the RO
cartridge(s). This forces the inlet water with high mineral
content out and surrounds the RO membrane(s) with RO
water on both sides.
The Flush Cycle is used to preserve the RO membrane during
periods of inactivity, such as overnight. The system will
resume normal operation when there is a demand for RO
water.
The system will automatically perform a Flush Cycle if there
has not been any flow for two (2) hours. If inactivity continues,
another Flush Cycle will be performed after 12 hours.
NOTE: The Everpure Conserv HE-3 RO System will perform
an automatic flush after 90 minutes of operation or
every 12 hours if it is idle.
26
WATER YOU CAN TRUST
Technical Support to obtain the
®
®
Set Customer Number
Customer # Location #
01 01234
1 2 3 4 5
7 8 9 0
X
Set Softener In Use
CES-9100TS E-30C
Water Softener In Use
no
Air Purge/Flush Menu
Perform Perform
Air Purge RO Flush
Perform
Perform
RO Rinse
Tank Fill
Air Purge/Flush Cycle
Flush Cycle in progress.
6