Table of Contents
Advertisement
This button will only display under the following
Clear
conditions:
Lockout
• The Main Pump (P1) is running.
• The system conditions are such that the
Storage Tank should be receiving RO
water.
• The Storage Tank is not filling.
• The Storage Tank Pump (P2) is not
running.
• 20 minutes have elapsed.
If the above conditions are true, then it is likely
there is a water leak in the system. In this
condition, the Conserv HE-3 RO System will
stop all incoming water flow. The Home Screen
buttons will turn to red and the Clear Lockout
button will be displayed. When the leak is
repaired, and no other faults are found, press
the Clear Lockout button to resume operation.
CAUTION: Any repair on the Everpure
System may compromise water flow and/or
water quality. After repairing the water system,
a thorough review must be made of the areas
affected. Change filters, flush or sanitize as
needed to restore water quality.
Displays the date as mm/dd/yy and the time as
Date and
HH:MM am/pm.
Time
System Status Menu Interface
The System Status Menu Displays:
Press to display inlet water conditions.
Inlet
Press to display prefilter life.
Pre
Filter
Press to display RO process information.
RO
Membrane
Press to display tank status.
RO Water
Tank
Press to display postfilter life.
Post
Filter
Used for filter life, system statistics, and
History
performance information.
The Inlet Status screen is displayed when the Inlet button is
pressed. All of the values represent real-time information.
• Inlet flow rate in gallons per minute (gal/min) or Liters
per minute (L/min).
• Inlet pressure as psi (MPa).
• Inlet TDS as ppm.
• Inlet water temperature in °F (°C).
EVERPURE
CONSERV
HE-3 RO SYSTEM INSTALLATION AND OPERATION GUIDE
®
®
Conserv
HE-3 RO
®
®
Conserv
HE-3
®
System
Reset
System
Status
Filter Life
Settings
Calibrate
Contact
Sensors
Info
Clear
Lockout
Date and
Time
System Status Menu
Pre
Inlet
Filter
Membrane
Post
RO Water
History
Filter
Inlet Status
Inlet Flow Rate
0.00 gpm
Inlet Pressure
0 psi
Inlet TDS
0 ppm
Inlet Water Temp
32 °F
RO
Tank
21
Advertisement
Table of Contents
