Chapter 3 Configuring The 2085-Ir8-Sc Using Ccw; Section 3.1 Introduction - Spectrum Controls Micro800 2085-IR8-SC User Manual

Chapter 3
Configuring the 2085-IR8-SC
Using CCW
This chapter covers the following subjects:
Section 3.1
Introduction
You use CCW software (v 9.00.00 and above) to configure the 2085-IR8-SC
Expansion I/O Module. Spectrum Controls, Inc. provides a custom configuration
software utility that you may use to provide configuration settings to the profile.
You then send the configuration setup to the module.
Your controller firmware must be at v. 9.011 and above as well.
The Micro850/870 Controller (Bus master) subsystem is located at the left end of
the bus. This subsystem is comprised of:
Optional:
•
How to use Connected Components Workbench (CCW) and optionally
ModuleConfigConverter.exe software to configure the Module.
•
Analog Data and Status settings.
•
Data Links settings.
•
Setting configuration parameters and associated values.
•
Micro800 Controller
•
Micro800 Expansion I/O Modules
•
2085-ECR Bus Terminator
•
2080-PS120-240VAC Power Supply (separate module or built-in the
main controller).
•
2080 Expansion Modules
•
2085-EP24VDC Expansion Power Supply for Micro870 Controller.
User's Manual Pub. 0300321-01 Rev. A