If Engine Does Not Start; Signalling Of Glow System Failures; Manipulation With Motor Starter - Zetor Proxima Series Operator's Manual

IF ENGINE DOES NOT START

Turn the key into position "0", wait 30
seconds and repeat starting.
Maximum 6 starting cycles are allowed
(15 seconds starting and 30 second
interruption make one cycle). Farther
starting of engine is allowed after cooling
of starter motor to
temperature.
Never help to the stopping engine
by the starter motor. There is
danger of damage of starter
motor.
DRIVING OPERATION
G204
SIGNALLING OF GLOW SYSTEM
FAILURES
Failure of glowing system is signalised by
flashing of the signalling lamp of glowing.
- If the signalling lamp of glowing is
flushing one times in one second at
stopped engine, glowing will take place
in emergency regime as at low
the ambient
temperature
temperature.
- If the signalling lamp of glowing is
flushing two times in one second at
stopped engine, glowing is put of
operation (out of function).
If the signalling lamp of glowing is
-
flushing
engine, failure of glowing regulator
occurred and glowing was not finished.
It is necessary to remove the failure
immediately, because there is danger
of battery discharging.
G205
regardless to coolant
permanently at running
52
MANIPULATION WITH MOTOR
STARTER
It is forbidden to start the
tractor by short circuit of
starter motor connectors!
Start the tractor
driver's seat only!
Disconnect the ground battery
pole, shift all levers into neutral
position, including PTO engage-
ment, when any manipulation
with starter motor or repairing it!
Starter motor connectors are
covered with a cover.
G206
from the