Switching The Units On; Operating Instructions (Valid For Canada) Cerec Af, Cerec Af Connect - Dentsply Sirona CEREC AF Connect Operating Instructions Manual

6 Installation and startup
6.5 Commissioning
36

Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect

Extension cable option
The following applies for the optional integration of a 50cm extension
cable:
1. Carefully release the connection between the CEREC Omnicam
cable and the camera cradle cable.
2. Carefully insert the connector of the CEREC Omnicam cable into the
coupling on the extension cable, watching out for the guide nose.
3. Insert the extension cable connector (which is now connected to the
CEREC Omnicam cable on the camera side) into the supply cable
coupling, watching out for the guide nose, so that the connection with
the coupling box cable is re-established.
Notes on network installation
CEREC AF/AI and the milling machine must be connected via LAN cable.
Your network operator must ensure that LAN cables and provided and
installed so that you can connect the PC to the milling machine.
The network card is installed.
6.5.3

Switching the units on

Prior to initial startup
Prior to initial startup, the wireless keyboard stick must be connected to a
USB port on the rear of the PC. As long as Windows has not yet been
activated, the USB port to the front of the PC is not detected as such. You
can reconnect the stick following activation on the front of the PC.
First startup
1. Switch on the PC for the first time. When activating the Windows
settings, you will be prompted to make a language selection. This is
a one-off procedure. This selection cannot be reset or changed at a
later date.
2. Set the monitor to its maximum resolution or the resolution
recommended by Windows.
3. Install the CEREC SW software on the CEREC AF /AI PC.
For CEREC AF Connect/AI Connect, download the Sirona Connect
SW software from the Sirona homepage. Confirm the firmware
update for the CEREC Omnicam with
4. Install the Splashtop Streamer. For this purpose, refer to the Sirona
Remote DVD and Operating Instructions (Sirona Remote DVD
booklet). The Sirona Remote Client is pre-installed on the tablet.
Establish a connection between the PC and tablet (see description in
the Sirona Remote DVD booklet). For the language setting on the
tablet, refer to "Tablet operating notes [ → 38]".
Dentsply Sirona
"YES"
.
66 37 487 D3652
D3652.201.01.14.02 10.2017