Software For The Cerec Omnicam; Cut Out Model Areas - Dentsply Sirona CEREC AF Connect Operating Instructions Manual

Dentsply Sirona
Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect
66 37 487 D3652
D3652.201.01.14.02 10.2017
7.5

Software for the CEREC Omnicam

Refer to the Operator's Manual for more information on using the CEREC
SW and the CEREC Premium SW.
You can find additional information on setting the CEREC Omnicam in the
"Adjusting the CEREC Omnicam" section of these Operating Instructions.
7.5.1

Cut out model areas

"Cut"
With the function, you can should be able to cut out model areas.
These can be areas in which parts of cotton rolls or cheeks were
unintentionally acquired.
When performing this activity, be careful not to accidentally cut out any
areas that e.g. are located behind the model or are otherwise cut away
from the line.
You can execute another scan of the area which you have cut out using
the crop function. To do so, close the tool window, by clicking on the top
right corner. You can refill the area with another acquisition.
"Undo" "Reset"
and
"Undo"
With the
the selected restorations since the tool was started.
"Reset"
With the
all restorations since the tool was started.
button in the tools you can undo all changes made on
button in the tools you can undo all changes made on
7 Operation
55