Application Settings - Teledyne BOA Spot ID Series Quick Start Manual

Web Server Application Settings
Some hardware changeable parameters of BOA Spot sensors are available on the
"Application Setup" page of the web server. To access, click the "Home" link and then
click the "Application Setup" link on the far right to access the following:
• You can enable or disable displaying a Recycle tolerance.
• You can select which solution the sensor loads at startup.
controlled from the script function.
• You can enable using a Template Solution (i.e. default settings for all solutions).
• You can upgrade an IDS model to the IDE model as indicated earlier in this guide.
Note: The sensor must be rebooted by clicking the "Apply Configure" button before
changes take effect.
When the inspection "Solution" is set up and stored on the sensor, the Ethernet
connection can be disconnected and the inspection will run autonomously (providing
you are not communicating with 3
The sensor can store up to 32 Solutions in its flash storage memory. These solutions
can be switched using the GUI or via PLC control, or hardware switch (page 27).
The BOA Spot administrator can setup user accounts. With password control enabled,
the web server will prompt users for a valid login.
BOA Spot ID Quick Start
Close the Web Browser while the BOA Spot reboots.
rd
party equipment using Ethernet)
42
Note: This can also be
Version 1.2; 2017-11-20