Pl-101 Specifications - Teledyne BOA Spot ID Series Quick Start Manual

PL-101 Specifications

The PL-101 module offers additional isolation for the BOA Spot sensor and simplifies
wiring at the control panel. The PL-101 is connected to the sensor through a single M12
cable. When using the PL-101, Power input PWR must be 24 Volts.
The I/O and RS-232 connections of BOA Spot are available through the PL-101.
Specification for these signals are as follows:
Specification
Voltage Load
Current GPO[0:1]
Protection Fuse
ICMN/OCMN
Common
Switch Time GPO[0:1]
PL-101 Connections
I/O connection to
BOA Spot
Control panel I/O
connections
BOA Spot ID Quick Start
Definition
24 V maximum
200 mA max @ 20°C
PTC fuses to 200 mA at 20°C or 150 mA at 70°C
PWR or GND as wired on respective OPTOs
800 Microseconds (ON or OFF, includes sensor switch time)
30
9 pin DSUB for
serial connection
Manual Trigger for
debugging
Version 1.2; 2017-11-20