Cable Configurations - Teledyne BOA Spot ID Series Quick Start Manual

Cable Configurations

The BOA Spot Vision Sensor offers flexible cabling to suit a number of application
configurations:
1. For typical applications, both the Ethernet and I/O-PWR cables are connected to
provide flexibility between the sensor and the control environment. In this
configuration, power is usually supplied by the I/O-PWR cable.
common to both BOA Spot connectors.
provided they come from the same power source. Do not connect different power
sources to the BOA Spot connectors.
2. For single cable applications that do not require I/O, the Ethernet cable can be used
to supply power
communications between the sensor and the control environment. Power is supplied
by connecting a DC voltage source between 12-30V to conductors (PWR and GND)
on the Ethernet RJ45 connector. In this configuration, the sensor I/O is unavailable.
Note: The PL-100 module supplies Passive Power on the Ethernet connection.
3. For single cable applications that do not require an Ethernet connection at runtime,
the I/O-PWR cable provides limited communications and power between the sensor
and the control environment.
connection is still required for setup.
Panel Link Modules
The PL-101 and PL-100 are optional modules that provide a safe and convenient way
to interface with BOA Spot. The PL-101 provides an isolation barrier between the
factory and the sensor I/O (differential isolation) and allows convenient panel wiring.
The PL-100 provides convenient Passive Power on the Ethernet connector.
PL-101
A-BVS2-PL-101
NOTE: The BOA Spot does not support the IEEE 802.3af standard Power over Ethernet
(PoE) and should not be directly connected to a PoE supported router.
BOA Spot ID Quick Start
(referred to as "Passive Power over Ethernet" or
Note: The PL-101 is for this configuration. An Ethernet
Either or both cables can supply power
Note: The PL-101 is for this configuration.
RJ45
RJ45
19
Note: Power is
PPoE) and
PL-100
A-BVS-PL-100
Version 1.2; 2017-11-20