Input Specifications - Teledyne BOA Spot ID Series Quick Start Manual

Input Specifications

The BOA Spot Vision Sensor provides three (3) dedicated opto-isolated, polarity
independent inputs. One of the inputs provides the acquisition Trigger function, while
the other two are general purpose.
Specification
Voltage ON
OFF
Current ON
Protection Resistance
Isolation
Common pin Input
Switch Time ON
OFF
Latency Trigger
The active polarity of each input is configured in iNspect for BOA Spot application, as
detailed on page 47. The sensor includes a noise filter on the input which is also
configurable.
To connect with an NPN source, connect the sensor's input (pin 5, 6 or 12) to the NPN
source output and the sensor's common input (pin 7) to PWR. When the source output
turns ON, the sensor's input will be pulled down turning the opto-coupler ON.
To connect with an PNP source, connect the sensor's input (pin 5, 6 or 12) to the PNP
source output and the sensor's common input (pin 7) to GND. When the source output
turns ON, the sensor's input will be pulled up turning the opto-coupler ON.
Input Diagram
BOA Spot ID Quick Start
Definition
11-30 V
0-3 V (12 V nominal threshold)
8.0 mA typical (24 V applied)
3.0 K Ohms
4000 V RMS
PWR or GND
20 Microseconds
10 Microseconds
62 Microseconds from trigger input to start of acquisition
NPN Wiring
7
5
PNP Wiring
5
7
26
Version 1.2; 2017-11-20