Installation; Connections & Pin-Outs - Teledyne BOA Spot ID Series Quick Start Manual

Installation

Connecting the BOA Spot Vision Sensor
This section details how to connect the BOA Spot Vision Sensor with its associated
components and factory environment.
Camera Connectors and Indicators
Designator
LAN
I/O PWR
LED 1
LED 2
LED LAN
NOTE: The BOA Spot does not support the IEEE 802.3af standard Power over Ethernet
(PoE) and should not be directly connected to a PoE supported router.
BOA Spot ID Quick Start
LAN 8 Pin
Definitions
10/100 BaseT Ethernet connection. Provides the primary
interface for configuring the sensor, developing the application
and monitoring results.
Note: The BOA Spot can be powered from the Ethernet cable
directly (Passive Power over Ethernet or PPoE).
Provides access to the sensor I/O – 3 IN, 3 OUT, RS-232. Also
provides PWR input (24-30V).
both connectors.
Blue Solid = Sensor booted, not configured (no Solution file)
Green Solid = Solution loaded, ready to run
Green blink = Solution loaded & running, acquisition in process
Red = Sensor Fault
Blue blink = Booting (should stop after 20 seconds)
Green = Inspection Pass (runtime decision result)
Blue = Inspection Recycle (runtime decision result)
Red = Inspection Fail (runtime decision result)
Blue = Warm reset or reboot
Red/Green/Yellow = Network activity
17
I/O PWR 12 Pin
Note: The power is common to
Version 1.2; 2017-11-20