Teledyne BOA Spot ID Series Quick Start Manual page 20

Ethernet and I/O Setup
1. Connect the M12-8 male end of the Ethernet cordset (A-BVS-E8S-X) to the M12-8
female connector labeled "LAN" on the sensor.
2. Connect the RJ45 end of the Ethernet cordset to the RJ45 on the client PC, PLC or
factory LAN (PC is only required for setup)
3. Connect sensor PWR, GND, trigger and I/O from the control panel to the breakout
screw terminals on the PL-101.
4. Connect one end of the M12-12 male IO-PWR cordset (A-BVS-PL101S-X) to the
M12-12 female connector on the sensor labeled "IO/PWR". Connect the other end of
the cable to the M12-12 female connector on the PL-101.
Setup client PC
BOA Spot ID Quick Start
BOA Spot
A-BVS-PL101S-X
A-BVS-PL-101
Outputs
20
A-BVS-E8S-X
Power
Inputs
Version 1.2; 2017-11-20